I've just got a airnet connection working for my tivo. I've managed to install tivoweb via the method described by Steve Conrad. I can connect to this fine, and even got it to start automatically via adding it to rc.sysinit.
However, I'm struggling to install endpad and loadlogo. I'm not sure if I'm doing something stupid (quite possible), or I've not installed something previously which is needed.
I've ftped endpad.tcl to the /var/hack directory
Loaded up bash
changed to the hack directory
chmod 755 endpad.tcl
run endpad.tcl with the relavant options
However, when I run endpad I get a command not found error.
Trying the obvious, I made sure the file existing in that directory, run it from the root directory using var/hack/endpad.tcl and /var/hack/endpad.tcl, rebooted the tivo and tried again. All came up with the same error.
Any suggestions / or pointing out any obvious things I'm doing wrong would be greatly appreciated.
I seem to recall having the same problem with a script.
I eventually found that I'd caused it by FTPing the script across using ASCII mode and this resulted in ^M being put at the end of every line.
Try looking at endpad.tcl and see if this is the case.